Premo Plastics - MK III Ignition Dispenser

The MK III is a compact and dependable aerial ignition device dispenser. Made of aluminum, the MK III is designed to safely inject PREMO’s Aerial Ignition Devices with ethylene glycol and accurately release them over targeted areas.



	The MK III is shaped to fit the rear doorsill of the Bell 206 Helicopter and can easily be adapted to any aircraft using auxiliary support brackets. The lightweight main frame contains the power train, glycol reservoir and pump, slipper blocks, and injection mechanism. Four Aerial Ignition Device chutes align with each slipper block to provide a controlled supply of Aerial Ignition Devices. Back to Top



	Controls for the MK III are easy to use with minimum operator manipulation. Power is supplied to the MK III from the aircraft power supply. The central control panel contains all electrical components and switches to control the various functions of the MK III. Each switch is series wired to enable you to operate the drive motor independently of the pump, but the pump will not operate unless the drive motor is turned on. This allows cycling of the unprimed Aerial Ignition Devices for testing and to guarantee optimal performance. Back to Top


The MK III is equipped with a 3.25L water reservoir for fire extinguishing within the internal chamber. In the event of blockage in the Aerial Ignition Device feed-chute, the feed-chutes can easily be de-assembled to allow access to clear any obstructions. And in the event of an emergency, the MK III can also be quickly ejected from the aircraft. Back to Top



- Holds up to 450 Aerial Ignition Device - Controlled Drop Rate of 15 to 100 Aerial Ignition Device - 3.25L Water Reservoir for Internal Chamber Safety - Electrical Panel Protected by Special Housing - Quick-Disconnect Fitting & Breakers for Optimal Safety - Packing Crate to Protect During Transport Back to Top